To overcome this, enable the DDNS, then edit the configuration to replace DDNS url with your public IP address. Some Internet Service Providers may change your IP address sometimes. Some countries/regions may block the VPN connection.The port you are using for OpenVPN Server is blocked by the Internet Service Provider, change to another port, or contact the Internet Service Provider.You may need setup port forwarding, please check here.The Internet Service Provider doesn't assign you a public IP address, please check here.There are several common reasons cause failed: Enable the connection, check if the phone has Internet access and whether its IP address is the IP of your OpenVPN Server. Then open the OpenVPN app, import the OpenVPN configuration we previously exported. The simpliest way is to use a cell phone with OpenVPN official client app installed, turn off its Wi-Fi connection, and only connect to Internet via 3G/4G/5G. To check if OpenVPN Server is working properly, we can use another device connected to another network and use the OpenVPN configuration we exported earlier to connect and see whether it connects properly and whether the IP address is the IP of OpenVPN Server. To check if OpenVPN Server is working properly ¶ Otherwise, you will not be able to connect to the OpenVPN server by using its configuration file. Export OpenVPN configuration file ¶Ĭlick Export Config on the bottom right to download the OpenVPN configuration file.Ĭlick Start to start your OpenVPN server. Note that you can't running VPN Client and Server at the same time, and also can't running OpenVPN Client and WireGuard Client at the same time. Click Apply when you finish.Īllow Access Local Network: Enable this will allow every client that connect to this OpenVPN Server be able to access your LAN. You can also click Modify to change them manually. There are preset OpenVPN server configurations. Setup OpenVPN Server ¶ Server configuration ¶ If you already have a main router, the GL.iNet router is several levels below it and you need to set up port forward on each level.Īccess to web Admin Panel, on the left side -> VPN -> OpenVPN Server.If you already have a main router, then the GL.iNet router is under the main router, you may need to setup a port forward on the main router.If GL.iNet router is the main router in your network, this is simple, please move to the next step.If no, you can't connect to the WireGaurd Server.Īn alternative method is to use a reverse proxy solution, we suggest AstroRelay. Please check if you Internet Service Provider assigns you a public IP address here. Make sure Internet Service Provider assigns you a public IP address ¶ For setup a WireGuard Server, please check out here. We recommend WireGuard over OpenVPN because it is much faster. GL.iNet routers have pre-installed OpenVPN Client and Server. OpenVPN is an open-source VPN protocol that makes use of virtual private network (VPN) techniques to establish safe site-to-site or point-to-point connections. To check if OpenVPN Server is working properly Make sure Internet Service Provider assigns you a public IP address
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |